background image

 

 

Stand 30-2032 

 

page 1 of 4 

FILIUS SCHATTELLO ALBATROS installation 
instructions: side sheets 

 

 

Thank you very much for purchasing a MAY sunshade. 
 

The following instructions include all information necessary for the correct mounting and handling 
of your MAY sunshade side sheets. For safety reasons, please read these instructions carefully 

and then keep them for later reference. 

 

Non-observation of operating instructions can result in damage 
to property. 

Please note that if these instructions are not observed, the manufacturer 
cannot assume any liability or guarantee. 

 

Always follow the safety regulations. 

 

Should you not understand any part of these mounting instructions, 

please contact your MAY dealer. 

 

Mounting the side sheet holder 

 

1.

 

Open the umbrella about halfway. 

  

2.

 

Remove the canopy tensioning hook from the telescopic shaft of the spoke. In order to do 

so, insert the tip of a screwdriver into the side slot and push off the end cap. Then press 
the telescopic shaft toward the centre mast and pull the hook outward. 

 

 

 

 

 

 

 

 
 

 

3.

 

Slide the side sheet holder along the spoke to the required position. Make sure that the 

side clamps of the holder are facing downward.

 

 

Attention 

 

side slot for  
screwdriver 

 

telescopic 
shaft 

 

end cap 

 

Summary of Contents for FILIUS SCHATTELLO ALBATROS

Page 1: ... the manufacturer cannot assume any liability or guarantee Always follow the safety regulations Should you not understand any part of these mounting instructions please contact your MAY dealer Mounting the side sheet holder 1 Open the umbrella about halfway 2 Remove the canopy tensioning hook from the telescopic shaft of the spoke In order to do so insert the tip of a screwdriver into the side slo...

Page 2: ...crew clockwise until the holder is clamped tight on the spoke 5 Tighten the M6 nut clockwise so that the eyelet screw cannot become loose 6 Hook the tensioning hook back onto the telescopic shaft and press the cap back on If the cap doesn t fit properly just turn it the other way round Connecting the form rods 1 Extra long rods are fitted into each other as shown below side clamps facing downward ...

Page 3: ...l all the snap hook straps are in position 3 Hook all the straps into the eyelet screws of the side sheet holders 4 Slide the next rod through the bottom sleeve Then insert a ground anchoring elastic band and continue sliding the rod as far as the next sleeve Repeat this procedure until all elastic bands are in position 5 Open the umbrella completely 6 In windy weather the side sheets can be kept ...

Page 4: ...1 1 1 1 1 1 1 1 1 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 1 1 1 1 1 1 1 1 1 1 1 1 1 1 Side sheet 1 Side sheet 2 Side sheet 3 Side sheet 4 Side sheet 5 Side sheet 6 Side sheet 7 Side sheet 8 Side sheet 9 Side sheet 10 Rain gutter 3 Rain gutter 4 Rain gutter 6 Rain gutter 5 Rain gutter 1 Rain gutter 2 Metal stamped numbers StNo on side sheets Side sheet 1 StNo ____ Side sheet...

Reviews: