N>Trans Manual - Maycom Audio Systems – Page 12
6.2 Connections and indicators
N>Trans
N>Trans Pro
1
Headphone Out
2
Unbalanced Stereo Input (Microphone/Line)
6V Mic Bias available
3
Balanced Right Mono Input (Microphone/Line)
4
Balanced Left Mono Input (Microphone/Line)
5
Balanced Stereo Input (Microphone/Line)
12V/24V/48V Phantom available
6
Peak Level LED Right
7
Peak Level LED Left
Use either Maycom supplied cables - see chapter 5; Available Accessories –
or use cables that are wired according to appendix B; Connector Wiring.
Use the left channel connection for single channel recording.
The peak level indicators are showing the status of the active audio stream.
Red
Overload - Signal is clipping
( > -1 dBFS )
Orange
Signal is near clipping
(-6 dBFS to -1dBFS)
Green
Level OK - Nominal signal level
(-20dBFS to -6dBFS)
If both input- and output-stream are active, the LEDs are showing the status of the input stream.
IMPORTANT NOTE:
The N>Trans Standard uses either the dual balanced mono inputs or the stereo
unbalanced input. Not a combination of those two. Do not try to fit a plug into the
unbalanced stereo input when one of the balanced mono inputs is occupied, it can damage
the N>Trans!
1
3
2
4
1
5
6
7
6
7
WARNING:
The phantom power is very high voltage compared to the voltages normal audio
equipments are designed to handle. You should be very careful to check that you do not
supply phantom power to the inputs where you have anything else than balanced
microphones or other equipments designed to handle phantom power properly. Applying
phantom power to equipment not designed to handle it might result a damage caused to
that equipment. Although more restricted, the same is true for the 6V Mic Bias.
