5
QUICK START
•
Before use, ensure the device is sufficently charged and check the manufacturer
’
s recommended pressure for
the item you are inflating.
•
Ensure the air hose is securely screwed into the compressor
•
Select the appropriate adaptor for the item you are inflating and screw into the air chuck.
•
Connect the adaptor into the valve of the item you are inflating.
•
To activate the compressor press the SET button on the display.
•
Wait approximately 2-3 seconds for the display to show a pressure before attempting to start the compressor.
•
The current pressure will be displayed, unit of measure can be changed (psi, bar, kPa, kg/cm2) by pressing the
“SET” button.
•
Press the On/Off button to start the compressor.
•
The compressor will run continuously until the On/Off button is pressed again.
•
The LED light will illuminate whilst the compressor is in use.
SETTING THE AUTOMATIC SHUT-OFF PRESSURE
•
The default set pressure is 35PSI.
•
Note:
The LCD will only show inflation pressures when the compressor is connected to a valve.
•
To switch between the different units (psi, bar, kPa, kg/cm2), press
the “SET” button
(FIG 4) until the
required units are displayed.
•
Press the “
-
“ or “+” button to choose the desired value. Holding the “
-
“ or “+” button will accelerate the
numerical change.
•
Once the desired value has been selected the screen will flash 3 times and the pressure will be set. Note: the
display value will revert to 0.0 until the compressor is being used.
•
Connect the adaptor into the valve of the item you are inflating.
•
Press the On/Off trigger button to start the compressor.
•
When the item to be inflated has reached the preset value the unit will automatically turn off.
•
To stop the compressor at any time press the On/Off button again.
NOTES:
•
The compressor will ‘sleep’ after 30
seconds of inactivity. The digital display will be blank during sleep mode.
To re-activate the compressor press the SET button on the display.
•
You may notice the actual pressure reading may drop after a couple of seconds, this is normal.
•
In automatic shut off mode the compressor will inflate approx 1.5 PSI over the pre set value before it cuts out
to compensate for pressure fluctuations during the inflation process
FIG 4
