9
4-Wire Power Supply Cord Connection
Remove center terminal block screw (B). Remove neutral
ground wire (E) from external ground conductor screw (A).
A
E
B
1.
Prepare to connect neutral ground
wire and neutral wire
B
C
E
2.
Connect neutral ground wire
and neutral wire
Connect neutral ground wire (E) and neutral wire (white or
center) (C) of power supply cord under center terminal block
screw (B). Tighten screw.
IMPORTANT:
A 4-wire connection is required for mobile homes
and where local codes do not permit the use of 3-wire connections.
3-Wire Power Supply Cord Connection
IMPORTANT:
Use where local codes permit connecting
cabinet-ground conductor to neutral wire.
4.
Connect remaining wires
Connect remaining wires to outer terminal block screws.
Tighten screws. Finally, reinsert tab of terminal block cover
into slot of dryer rear panel. Secure cover with hold-down
screw.
Now, go to “Venting Requirements.
”
A
F
Connect ground wire (F) (green or bare) of power supply cord
to external ground conductor screw (A). Tighten screw.
3.
Connect ground wire
4-wire receptacle
(NEMA type 14-30R)
4-prong plug
Spade terminals
with upturned ends
Ring terminals
3-wire receptacle
(NEMA type 10-30R)
3-prong plug
Spade terminals
with upturned ends
Ring terminals
