5
INSTALLATION INSTRUCTIONS
Tools and Parts
Gather the required tools and parts before starting installation. Read and follow the
instructions provided with any tools listed here.
Parts supplied
Remove parts packages from dryer drum. Check that all parts are included.
4 Leveling legs
NOTE:
Do not use leveling legs if installing the dryer on a pedestal.
Parts needed
Check local codes and with gas supplier. Check existing gas supply, electrical supply and
venting. Read “Electrical Requirements,” “Gas Supply Requirements” and “Venting
Requirements” before purchasing parts.
■
For close-clearance installations between 31.5" (80.01 cm) and 37" (93.98 cm), see “Plan
Vent System” section for venting requirements.
Mobile home installations require special parts (listed following) that may be ordered by
calling the dealer from whom you purchased your dryer. For further information, please refer
to the “Assistance or Service” section.
■
Mobile Home Installation Kit. Ask for Part Number 346764.
■
Metal exhaust system hardware.
Optional Pedestal
Are you placing the dryer on a pedestal? You have the option of purchasing pedestals of
different heights separately for this dryer. You may select a 10" (25.4 cm) pedestal or a
15.5" (39.4 cm) pedestal with a storage drawer. The pedestal will add to the total height of the
dryer for a total height of approximately 46" (116.8 cm) or 51.5" (130.8 cm), respectively.
For a garage installation, you will need to place the 10" (25.4 cm) pedestal at least
9" (22.9 cm) above the floor. You will need to place the 15.5" (39.4 cm) pedestal at least
3" (7.6 cm) above the floor.
The pedestals are available in several colors.
To order, call the dealer from whom you purchased your dryer or refer to the “Assistance or
Service” section.
Stack Kit
Are you planning to stack your washer and dryer? To do so, you will need to purchase a Stack
Kit. To order, call the dealer from whom you purchased your dryer or refer to the “Assistance
or Service” section. Ask for Part Number 8212640.
■
8" or 10" pipe wrench
■
8" or 10" adjustable wrench (for gas
connections)
■
Flat-blade screwdriver
■
Adjustable wrench that opens to 1" (2.5
cm) or hex-head socket wrench (for
adjusting dryer feet)
■
¹⁄₄
" nut driver or socket wrench
(recommended)
■
Level
■
Knife
■
Vent clamps
■
Pipe-joint compound resistant to LP gas
■
Caulking gun and compound (for
installing new exhaust vent)
■
Pliers
■
Tape measure
37"
(93.98 cm)
Optional pedestal (15.5" [39.4 cm] model shown)
P
edestal Height
Color
Part Number
10" (25.4 cm)
White
MHP1000SQ0
10" (25.4 cm)
Black
MHP1000SB0
15.5" (39.4 cm)
White
MHP1500SQ0
15.5" (39.4 cm)
Black
MHP1500SB0
15.5" (39.4 cm)
Pacific Blue
MHP1500SK0
Summary of Contents for Epic MGD9800T
Page 29: ...29 Notes ...
