31
E. CLEARING CREDIT/CLEARING CYCLE
Credit can be cleared from either dryer pocket by using the following key combination. With the program switch
down, press and hold the PAUSE key while entering HI-HI-HI-LO-LO-MED. The combination is the
HI key three (3) times followed by the LO key two (2) times and then the MED key one (1) time.
Wait 1-second for the control to prompt the user with CLEAR CREDIT? If you want to proceed, simultaneously
press the PAUSE button and one (1) of the remaining keys. This will clear the credit.
A cycle in free mode can be cleared by one (1) of the following two (2) options. The same key combination as
clearing credit in coin mode can be used. With the program switch down, press and hold the PAUSE key
while entering the following key combination: HI-HI-HI-LO-LO-MED. Wait 1-second for the control to
prompt the user with CLEAR CYCLE? If you want to proceed, simultaneously press the PAUSE button
and one (1) of the remaining keys. This will clear the cycle. Another way of clearing a cycle in free mode is to
press and hold the PAUSE key for 3-seconds.
F. ACCESSING COIN VAULT
The coin vault can be accessed by placing the program switch into the UP position. Once the program switch
is in the UP position, press the HI key. The controller will now display the amount of money in the coin
vault. Press the HI key again and the controller will ask to CLEAR COIN VAULT TOTAL? Press
PAUSE for NO and press MED for YES.
G. WRINKLE GUARD
This program keeps items wrinkle-free when they are not removed from the dryer promptly at the end of the
drying cycle and/or cooling cycle.
When the drying and cooling cycles are completed, the dryer will shut off, the tone will sound, and the liquid
crystal display (L.C.D.) will read CYCLE DONE. If the door is not opened, the Phase 7 dual coin microprocessor
controller (computer) will wait an initial 15 minutes delay time. Once the initial 15 minute delay time has expired,
the fan will start and the basket (tumbler) will rotate (without heat) for an ON time of 15-seconds. When the fan
and basket start, the display will read WRINKLE GUARD. Immediately following the 15-second ON time,
the control will go into a 5 minute OFF time at which point it will display CYCLE DONE. The Phase 7 dual
coin microprocessor controller (computer) will repeat this process of 15-seconds ON and 5 minutes OFF
until either the doors are opened or 99 minutes have elapsed, whichever comes first. Prior to each ON time,
there is a 3-beep warning that the fan and basket (tumbler) rotation are about to start. The beeps at the end of
the Wrinkle Guard Cycle can be programmed to be ON/OFF.
