15
WASHER CARE
Cleaning Your Washer
Use a soft, damp cloth or sponge to wipe up any spills such as detergent or bleach from the
outside of your washer.
Clean your washer interior by mixing 1 cup (250 mL) of chlorine bleach and 2 cups (500 mL)
of detergent. Pour this mixture into your washer and run it through a complete cycle using hot
water. Repeat this process if necessary.
Remove any hard water deposits using only cleaners labeled as washer safe.
Cleaning the liquid fabric softener dispenser (on some models):
1.
Remove dispenser by grasping top with both hands and squeezing, while pushing upward
with thumbs.
2.
Rinse dispenser under warm water, then replace it.
NOTE:
Some models are equipped with a liquid fabric softener dispenser. To avoid damage to
the washer or clothing, do not wash clothes with the liquid fabric softener dispenser removed
or add detergent or bleach to this dispenser; it is for liquid fabric softener only.
Water Inlet Hoses
Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Periodically inspect
and replace inlet hoses if bulges, kinks, cuts, wear or leaks are found.
When replacing your inlet hoses, mark the date of replacement on the label with a permanent
marker.
Moving and Storage
Because some water may stay in the hoses, freezing can damage your washer. If storing or
moving your washer during freezing weather, winterize it.
Winterizing your washer
1.
Shut off both water faucets. Disconnect and drain water inlet hoses. Pour 1 qt (1 L) of R.V.-
type antifreeze into the basket.
2.
Run washer on a drain and spin setting for about 30 seconds to mix the antifreeze and
remaining water.
3.
Unplug washer or disconnect power.
To use washer again
1.
Flush water pipes and hoses. Reconnect water inlet hoses. Turn on both water faucets.
2.
Plug in washer or reconnect power.
3.
Run the washer through a complete cycle with 1 cup (250 mL) of detergent to clean out
antifreeze.
Storage, non-use or vacation care
Operate your washer only when you are at home. If you will be on vacation or not using your
washer for an extended period of time, you should:
1.
Unplug washer or disconnect power.
2.
Turn off the water supply to the washer. This helps avoid flooding (due to a water pressure
surge) while you are away.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
Summary of Contents for MTW5707TQ0
Page 21: ...21 Notes ...
