19
3.
Remove the 4 screws from the opposite side of the door.
4.
Install the 2 hinges to the front panel of the dryer using 4 screws. Use the non-slotted side
to attach the hinge to the front panel.
5.
Install screws in the top hinge holes in the door. Do not tighten screws. Leave
approximately ¼" (5 mm) of screw exposed.
6.
Hang door by placing screw heads into top slotted holes of hinges and slide door down.
Align bottom screw holes in hinge and door. Install two bottom screws. Tighten all hinge
screws.
7.
Close door to engage door strike.
Complete Installation
1.
Check that all parts are now installed. If there is an extra part, go back through the steps to
see which step was skipped.
2.
Check that you have all of your tools.
3.
Dispose of/recycle all packaging materials.
4.
Check the dryer’s final location. Be sure the vent is not crushed or kinked.
5.
Check that the dryer is level. See “Level Dryer.”
6. In the U.S.A.
■
For power supply cord installation, plug into a grounded outlet. For direct wire
installation, turn on power.
In Canada
■
Plug into a grounded 4 prong outlet. Turn on power.
7.
Remove any protective film or tape remaining on the dryer.
NOTE:
Glass door models have a protective film on the window that should be removed.
8.
Read “Dryer Use.”
9.
Wipe the dryer drum interior thoroughly with a damp cloth to remove any dust.
10.
Test dryer operation by selecting a Timed Dry heated cycle and starting the dryer. For this
test, do not select the Air Fluff modifier.
If the dryer will not start, check the following:
■
Controls are set in a running or “On” position.
■
Start button has been pushed firmly.
■
Dryer is plugged into an outlet and/or electrical supply is on.
■
Household fuse is intact and tight, or circuit breaker has not tripped.
■
Dryer door is closed.
This dryer automatically runs an installation diagnostic routine at the start of its first cycle.
If you receive an “L2” code, there may be a problem with your home power supply keeping
the dryer’s heater from turning on.
See “Troubleshooting.”
If you receive an “AF” code, your dryer vent may be crushed or blocked.
See
“Troubleshooting.”
NOTE: You may notice an odor when the dryer is first heated. This odor is common when
the heating element is first used. The odor will go away.
A. Install these screws first.
A
A
