25
Changing Modifiers and Options after pressing Start
You can change an Option or Modifier anytime before the selected Option or Modifier
begins.
1.
Press PAUSE/CANCEL once.
2.
Select the new Option and/or Modifiers.
3.
Press START to continue the cycle.
NOTE
: If you happen to press PAUSE/CANCEL twice, the program clears and your dryer shuts
down. Restart the selection process.
Changing the Preset Dryness Level Settings
If all of your loads on all Sensor Dry cycles are consistently not as dry as you would like, you
may change the preset Dryness Level settings to increase the dryness. This change will affect
all of your Sensor Dry cycles.
Your Dryness Level settings can be adjusted to adapt to different installations, environmental
conditions or personal preference. There are 3 drying settings: 1 (factory preset dryness level),
2 (slightly dryer clothes, approximately 15% more drying time) and 3 (much dryer clothes,
approximately 30% more drying time).
1.
The Dryness Level settings cannot be changed while the dryer is running.
2.
Press and hold the DRYNESS button for 5 seconds. The dryer will beep, and “CF” will be
displayed for 1 second followed by the current drying setting.
3.
To select a new drying setting, press the DRYNESS button again until the desired drying
setting is shown.
NOTE:
While cycling through the settings, the current setting will not flash, but the other
settings will flash.
4.
Press START to save the drying setting.
5.
The drying setting you selected will become your new preset drying setting for all Sensor
Dry cycles.
Drying Rack Option
Use the Drying Rack to dry items such as sweaters and pillows without tumbling. The drum
turns, but the drying rack does not move.
If your model does not have a drying rack, you may be able to purchase one for your model.
To find out whether your model allows drying rack usage and for information on ordering,
please refer to the front page of the manual or contact the dealer from whom you purchased
your dryer.
NOTE:
The drying rack must be removed for normal tumbling. Do not use the automatic cycle
with the drying rack.
To use the drying rack
1.
Open dryer door.
2.
Place drying rack inside dryer drum, positioning the back wire on the ledge of the inner
dryer back panel. Push down on front edge of drying rack to secure at the front of the
dryer.
3.
Put the wet items on top of the drying rack. Leave space between the items so air can
reach all the surfaces.
NOTE:
Do not allow items to hang over the edge of the drying rack.
4.
Close the door.
5.
Press the POWER button.
6.
Select a timed drying cycle and temperature (see following chart). Items containing foam,
rubber or plastic must be dried on a clothesline or by using the Air Fluff temperature
setting.
7.
You must select a time by pressing TIMED CYCLE ADJUST Up or Down. Reset time as
needed to complete drying. Refer to the following table.
8.
Press (and hold) START button (about 1 second).
A. Front edge
A
A. Dryer rack front edge
B. Dryer back panel
A
B
