19
TROUBLESHOOTING
Possible Causes
Solution
Dryer Results (cont.)
Stains on load
Improper use of fabric softener.
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can
stain your garments.
Loads are wrinkled
The load was not removed from
dryer at the end of the cycle.
Refer to garment care label instructions. Dry clean only
garments are not recommended.
The dryer was tightly packed.
Dry smaller loads that can tumble freely.
Stains on drum
Loose dyes in clothes.
Drum stains are caused by dyes in clothing (usually blue
jeans). These will not transfer to other clothing.
First try the solutions suggested here or visit our website at www.maytag.ca
for assistance and to possibly avoid a service call.
If you experience
Load removed before cooldown
portion of cycle complete.
Allow the dryer to complete the cooldown portion of the cycle
before removing the load.
Load too hot
Using Timed Dry cycle with a
normal temperature setting.
Select a Sensor cycle with a lower heat setting to avoid
overdrying the load.
Odors
Recent painting, staining, or
varnishing in the area where your
dryer is located.
Ventilate the area. When the odors or fumes are gone from
the area, rewash and dry the clothing.
