3
Setting the Automatic Mode
To Change the Automatic Mode settings
First press the Manual/Automatic select button, then set according to the following table:
Cleaning cycle
indicator
This determines
the cleaning cycle
time. The RCU
allows you to
choose between
the following
options.
Fast
Efficient
(Default setting
)
Extra
Supreme/Pulit
1.5 hour cycle
2.5 hour cycle for
everyday use
3.5 hour cycle
Residential
cleaners
2 hour cycle
3 hour cycle for
everyday use
4 hour cycle
Commercial
cleaners
4 hour cycle
6 hour cycle for
everyday use
8 hour cycle
Delay Time
indicator
This determines
when the pool
cleaner starts to
work.
A delay allows the
dirt to settle to the
bottom of the pool.
Immediate start
(Default setting)
One Hour delay
Two Hours delay
Cleaning action
indicator
Allowing you to
choose from the
following options.
Standard
Floor and wall
cleaning.
(Default setting)
Ultra-clean
Stronger suction and
slower movement
Floor and cove
cleaning only.
Floor only
Cleans only the
floor and coves.
Walls Only
Cleans walls
and waterline
only.
Note:
x
After 2 minutes, if no button is pressed, the Remote Control Unit will shut-down and the
Pool cleaner will continue to work in the previous settings
x
When the "Ultra-Clean" and "Walls Only" options finish their cycles, the RCU will return
to default settings.
Summary of Contents for 2010
