Preface
General information
HeatMiser II
Installation guide. © 2014, all rights reserved
P a g e
|
5
GENERAL INF ORM ATION
This manual provides information relating to the installation, operation and maintenance
of the HeatMiser II solar collector. We recommend you read this manual thoroughly and
keep it for future reference.
HeatMiser II, solar collector for swimming pools, is simple to install and easy to operate.
The installation instructions described in this manual are based on the following
assumptions:
1.
You already have a pool that is completely set up and filled with water.
2.
Your pool is equipped with a pump and operational water filtering system.
3.
You have the necessary hoses needed to feed water in and out of your pool and
filter system.
Once installed, HeatMiser II will completely be dependent on the existing pool's filter
pump to push water in and through the solar collector.
HOW DOES IT WORK?
When properly installed, HeatMiser II will be connected to your filter and your pool by
two hoses: One will feed cold, filtered pool water from your pump into the collector. The
other, will feed water warmed by the sun to your pool via the pool return inlet. As cold
water is fed into the HeatMiser II, it flows through the individual riser tubes in the incased
glazing. The sun radiation is harvested by the collector and heats the water in the tubes
which is carried back into the pool.
