Preface
General information
HeatMiser II
Installation guide. © 2014, all rights reserved
P a g e
|
6
UNPACKING THE SOLAR COLLECTOR
Carefully remove the collector and all its components from the box. Before you begin,
make sure all parts detailed on page 7 are present.
TOOLS & EQUIPMENT RE QUIRED
The following items are not included with the product, but are required for a proper
assembly and operation:
-
Flat head screwdriver
-
Section of Hose to connect HeatMiser II to pool system
FAMILIARIZE YOURSELF WITH YOUR SURROUNDIN GS
Before you begin assembling, it is a good idea to know certain specifications about your
pool:
-
How big is your pool?
-
How many gallons of water does it hold?
-
What type of connections does your pool require?
-
What is the ideal location of the solar collector for the ultimate exposure to the sun?
CHOOSING THE I DEAL P OSITION
Your solar collector is designed to be installed on the ground next to your existing pump
and filter system. Locate a hard leveled surface. You will need to position the solar
collector at a safe distance away from the pool so it cannot be used by children as a step
to obtain access to the water. Make sure the place you have chosen is exposed to the sun
at least 6 daily hours. Avoid areas that might be shaded at different intervals of the day.
Use the supplied stand to angle the collector so it is facing the sun.
NOTE: HeatMiser II must be installed between the filter and the pool water inlet,
AFTER the water is filtered to prevent dirt and debris from clogging the riser tubes.
