initial operation
Winterizing
HeatMiser II
Installation guide. © 2014, all rights reserved
P a g e
|
15
INITIAL OPERATION
Once the solar heater has been assembled and the hoses are connected to the filter pump and
pool return, unblock the flow of water into the pool return hose and turn on the pump and
filter system. Bubbles will shoot out of the return nozzle into the pool initially while air is
pushed out of the solar collector. If this persists for longer than 2 or 3 minutes, check for and
repair any leaks in the hoses or connections.
Be sure to place your pool cover on at night and whenever pool is not in use to retain
the heat generated by the solar collector during the day.
MAINTENANCE
The solar collector should not require servicing or maintenance other than winterizing. Prior
to the first frost, or at the end of your swim season, the solar collector MUST be removed
from its connections to the pool and stored in a frost free location.
Before storing and prior to the beginning of the season, glazing should be cleaned with a soft
sponge or cloth made from 100% cotton using lukewarm water and a mild dishwashing
detergent. Glazing should then be rinsed with cold water.
Avoid other cleaners, gasoline or petroleum based solvents, sharp objects or any dry
cleaning as it may damage the glazing!
WINTERIZING
Drain all the water from the solar collector by disconnecting all pipes. Store in a location
protected from frost.
Do not allow standing water inside the solar collector to freeze. Water expands as it
freezes and can rupture the riser tubes of the collector.
