15
1031012 Rev.A 09/05
FUNCTION TEST, continued
18
Progressive Car Find®
1. Press the PANIC BUTTON once - Horn should beep five times and parking lights should flash five times.
2. Press the PANIC BUTTON a second time - Horn should beep five times but sound a little louder and parking
lights should flash five times.
2. Press the PANIC BUTTON a third time - Horn should beep five times but sound even louder and parking lights
should flash five times.
Security Functions
1. Press the LOCK button on the transmitter again - Should have the same result as previously seen. This arms
the security system.
2. DOOR TRIGGERS; Reaching through the previously opened driver’s door window, unlock the doors using the
manual lock mechanism then open the driver’s door - The security system should trigger (the horn should
start beeping intermittently and the parking lights should start flashing). Press the UNLOCK button to disarm
the security system. Repeat this procedure for the remaining passenger doors.
3. INTERIOR THEFT SENSOR (IT-s®); THIS SYSTEM IS EQUIPPED WITH AN IT-s® SHOCK SENSOR BUT IT IS
TURNED OFF IN THE MODULE’S SOFTWARE. IT CAN BE TURNED ON AND SET BY FOLLOWING THE
INSTRUCTIONS IN SECTION 18 BUT IT SHOULD NOT BE SET UNTIL VEHICLE PREP IF THE CUSTOMER
WANTS IT TURNED ON.
4. STARTER INTERRUPT; Rearm the security system, enter the vehicle through the driver’s door and try starting
the vehicle with the ignition key - The security system should trigger and the vehicle should not crank. Disarm
the security system by pressing the unlock button on the transmitter and try starting the vehicle again - the
vehicle should crank and start at this time, shut the vehicle off.
Remote Engine Start Functions
1. REMOTE ENGINE START; Make sure the key is removed from the ignition switch and the engine hood is
closed. Press the LOCK button followed by the START button - The parking lights should flash three times, the
horn should beep once then the vehicle should crank and start. Once started the parking lights will turn on and
stay on signifying the vehicle is started.
2. RUNNING WITH IGNITION KEY - While the vehicle is running on the remote engine start, press the UNLOCK
Button and enter the vehicle, insert the ignition key and turn the ignition to the run position, press the brake
pedal - At this time the vehicle should be running on the ignition key and the remote engine start was shut down
when the brake pedal was pressed. Turn off the ignition switch and the vehicle should shut off.
3. BRAKE PEDAL SAFETY - Restart the vehicle using the remote engine start, press UNLOCK button and enter
the vehicle, press the brake pedal - The vehicle should shut off.
4. KEY-IN -SENSE; Insert the ignition key into the ignition switch but keep in off position, activate the remote
engine start function - the vehicle should flash the lights as if it is going to start but then the remote engine
starter does not attempt to start the vehicle since it senses the key in the ignition.
5. HOOD SAFETY SWITCH; Open the engine hood and activate the remote engine start function - The horn should
beep two additional times signifying that hood safety switch is tripped and the vehicle will not start.
FUNCTIONAL TESTING IS NOW COMPLETE.
