4
1031012 Rev.A 09/05
FIGURE S
HOOD SAFETY SWITCH MOUNTING CONTINUED
5. Locate the hood release cable grommet from inside the occupant compartment. (FIGURE R)
6. Pull the hood release cable and grommet approximately 20” into the driver’s side footwell.
(FIGURE S)
7. Using fish wire, pull the hood safety switch wiring through the hood release cable opening:
a. From inside of the vehicle, insert the fish wire through the hood release cable opening.
b. Bend approximately three (3) inches of harness at wire end.
c. Using electrical tape, secure fish wire to harness as shown. (FIGURE T)
d. Pull fish wire and wiring through hood release cable opening. (FIGURE L, page 3)
e. Tape the hood safety switch wires against the fish wire and electrical tape in place. (FIGURE U)
f. Slide the fish wire and wiring through the hood release grommet and pull the excess wiring
through the grommet. (FIGURE V)
8. Reconnect the hood release cable:
a. Pull the hood release cable back into position. Reattach to hood latch release mechanism and
two (2) retaining clips. (NOTE: Ensure the hood latch cable retaining collar is seated securely).
b. Remove the tie wrap from the hood latch release mechanism.
c. Slide the hood release cable grommet back into position in the vehicle dashwall.
3
FIGURE V
FIGURE R
FIGURE U
FIGURE T
