11
10. Insert the hood switch harness (white) terminal to the
empty terminal of the vehicle wiring harness 18 pin
connector (terminal F).
CX-3
9. Route the hood switch harness along the vehicle wiring
harness and secure it with 3 wire ties (black).
Vehicle front
[Vehicle wiring harness 18 pin connector]
(Connector viewed from wiring harness side)
Hood switch harness (White)
Insert Terminal
Insert hood switch harness (White)
terminal to empty terminal.
Vehicle wiring harness
18 pin connector
F
<Terminal insertion procedure>
Terminal
Retainer
Terminal
<Terminal insertion procedure>
(b) Insertion terminal
(a) Remove retainer
(c) Reinstall retainer
Retainer
Terminal
Terminal
•
When connecting a terminal to a connector, always refer
to the following, <Terminal insertion procedure>.
• Connect the harness terminal to the specified signal line
because a system or vehicle malfunction may occur if it
is connected incorrectly.
Caution
Vehicle front
Hood switch harness (Black)
Electro tap and
electrical vinyl tape
Vehicle wiring harness
18 pin connector
Terminal:A (Black)
Hood switch harness (Black)
[Vehicle wiring harness 18 pin connector]
(Connector viewed from wiring harness side)
11. Branch connect the hood switch harness (Black) to the
vehicle wiring harness 18 pin connector (terminal A (Black))
using an electro tap, and wrap the electro tap using
electrical vinyl tape.
• Connect the electro tap to the specified signal line because
a system or vehicle malfunction may occur if it is connected
incorrectly.
•
For branch connection procedure using electro tap, refer to
[4. CONNECTION USING ELECTRO TAP] on page 4.
Caution
Vehicle Front
Vehicle Front
Mazda2
9. Route the hood switch harness along the vehicle wiring
harness and secure it with 3 wire ties (black).
Hood switch harness
3 x Wire Ties
(Black)
Vehicle wiring
harness clip
Shroud panel
Vehicle Front
Mazda2
Vehicle Front
CX-3
Hood switch harness
3 x Wire Ties
(Black)
Vehicle wiring
harness clip
Shroud panel
Vehicle wiring
harness clip
