19
3 x Double-sided
adhesive tapes
(25 x 25 mm)
Protective Pad
Vehicles with protective pad on glove box undercover
(Steps 42 to 50)
42. Peel off part of the protective pad and clean off adhesive
residue from the glove box undercover.
Caution
•
Use 3M Promoter-4298 for primer.
•
When degreasing using primer, only apply primer to indicated
area to prevent other parts from becoming discolored.
•
After degreasing using primer, let it dry for 1 min. or more.
43. Degrease the indicated areas of Glove Box under cover
using primer.
44. Apply 3 Double-sided adhesive tapes (25 x 25 mm) to the
Glove Box under cover on 3 indicated locations.
45. Degrease the bottom side of the MMS ECU using primer.
46. Place the MMS ECU on Glove Box undercover as shown
and ensure Double-sided adhesive tape secures MMS
ECU to the Glove Box undercover.
47. Apply the Double-sided adhesive tape (25 x 69mm) on the
MMS ECU as indicated.
48. Reapply the protective cover over the MMS ECU securing
it with the Double-sided tape.
Caution
•
Ensure MMS ECU harness connector, GSM and TEL
connectors are plugged into the MMS ECU before attaching
to the Glove Box under cover.
•
Ensure ECU is properly aligned as shown.
ALIGNMENT
49. Cut 1 Urethane foam tape into 2/3 size.
50. Apply 1 and the 2/3 sized Urethane Foam tapes to secure
the MMS Harness, GPS and TEL cables on the Glove Box
under cover.
Note
2/3 Urethane
Foam tape
1 Urethane
Foam tape
Double-sided
Adhesive tape
(25 x 69mm)
Protective Pad
