BODY STRUCTURE [PANEL REPLACEMENT]
09-80B–82
REAR SIDE FRAME INSTALLATION[PANEL REPLACEMENT]
id098008801300
1. Make a reinforcement panel using the material from the rear side frame.
2. To cut-and-join the new and existing parts, cut at the locations for the new part indicated in the figure below and
bevel the locations where the new and existing parts are joined.
3. When installing the new parts, trial-fit new and existing parts, then measure and adjust the body to conform
with standard dimensions.
4. After temporarily installing new parts, make sure the related parts fit properly.
5. Trial-fit the new and existing parts, weld the existing parts and the reinforcement, and then butt weld the new
and existing parts.
Caution
•
Press fit the reinforcement panel and the body side material, and then weld them.
End Of Sie
L=10mm x 4
{0.39in}
L=10mm x 4
{0.39in}
50mm
30mm
t=1.8mm
REINFORCEMENT
{1.18in}
{1.97in}
{0.07in}
L=10mm x 4
{0.39in}
REAR SIDE FRAME
145mm
{5.71in}
CUT-AND JOIN
LOCATION
acxuub00000134
3419-1U-06C(09-80B).fm 82 ページ ２００６年３月２４日 金曜日 午後４時４７分
