Page
8
of
24
2)
OPERATION INSTRUCTIONS
Lighting the stove
1.
Open the door and ensure the secondary/ air-wash control lever is
opened fully. It
’
s the control on the right.
2.
On first lighting, we recommend using 2 - 3 firelighters along with
wood kindling built in a pyramid above the firelighters to obtain a
good fire bed. Ignite the firelighters then close the stove door and
allow the firelighters and wood kindling to ignite to the point where
the embers are glowing.
3.
Add your fuel of choice and control the stove as advised. Burn small
loads initially in your new appliance before full fires are used, to
allow paint & fitting cement to cure.
Controlling Stove
Burning wood:
•
Air-wash/secondary air lever (The control to the right) - Use this to
control the fire when burning wood.
•
Primary air control lever (The control to the left)
–
This should be
closed as wood does not need air from below to burn effectively.
•
Avoid overloading your appliance as this may cause damage to the
product and cause unstable burn conditions. See max fuel load stated
in ‘Refuelling Wood’ section for more in
fo.