For additional technical information on this and all MB QUART products, go to
the “SUPPORT” tab at MB QUART.com
There you will find helpful, FAQ, TEQ Tips and you can contact Technical Support via email.
©2018 Maxxsonics USA
MOUNTING THE PODS TO RZR
STEP 8 - TAPE IT OFF
Using colored painters tape, you need to mark the fender of the RZR where you will need to
drill. To do this, hold an empty left or right pod in your hand. Hold the pod into place to
approximate the position of the mounting holes on the internal fender.
Set the unit down and put colors tape onto the fender behind the pod until you can see the tape
through the mounting holes when you hold the pod back into place.
Next, use your Sharpie to mark the mount holes on the painters tape. Repeat the mounting
process for the other pod.
STEP 9 - DRILL
Drill (4) 5/16 inch holes into the fender where you marked the tape.