4
1. Scope of Delivery
The mbl 111F Radialstrahler Hybrid is delivered in three shipping boxes. In the two smaller ones you will fi nd:
2 x woofer units
4 x copper jumpers
2 x cover plate
In the other box (solid case) you will fi nd:
2 x tweeter-midrange sections complete with cover grille
operating instructions
fi nal production protocol
Allen wrench
8 x special spikes and spike nuts
8 x spikes, spike nuts and brass washers
warranty card
2. Unpacking
Set all the boxes on the fl oor with the arrows on the edge of the box pointing up. (Fig. 1)
First, you should take the woofer units out of their packaging (the smaller boxes). This works best, if you open the
top of the box and then carefully turn it upside down and pull off the box upwards. Remove the foam plastic and
put it back into the box, open the cotton bag at the bottom and turn the woofer units back over, so they are in an
upright position. Place the woofer units approximately where you want to set the speakers.
Open the solid case on the front (Fig.1). Remove the board lying on the top and the tube-shaped cardboard.
The mbl 111F tweeter/midrange section is screwed to the board you can see at the bottom. Lift the section and the
wooden board out of the box and lay it carefully on its back so that the wooden board can hang freely (Fig.2). Use
the enclosed Allen wrench to unscrew all four Allen screws.
Fig. 1: Opening the wooden case
Fig. 2: Lifting the HT/MT section and the wooden board
Summary of Contents for 111F Radialstahler Hybrid
