35
Troubles
Possible cause
Action
Double feed occurs
frequently.
Separator pressure is too weak.
Select stronger separator pressure.
Paper feed pressure is too strong.
Select weaker paper feed pressure.
Empty feed occurs
frequently.
Paper feed pressure is too weak.
Select stronger paper feed pressure.
Separator pressure is too strong
Select weaker separator pressure.
Sheets are curled at the edges because
they were copied.
Set sheets upside down on a feed table.
Paper becomes dirty.
Paper feed rubber rollers, separators,
transport belts, are dirty.
Clean the rollers, separators, and /or belts.
The EJECT lamp shows.
The stacking table is not set properly.
Set the stacking table properly.
The machine and stacking table are not
installed at level place.
Install them at level place.
The paper ejection area of the machine
are exposed to direct light.
Shade light with curtains or the like, or move the
machine to a darker place so that the ejection area
will not be exposed to direct light.
Ejection sensor are dirty.
Cleaning of
discharged sheet photo sensor
The collator suddenly
runs fast.
The paper ejection sensor malfunctions
when hands or foreign objects enter the
ejection area while the machine is in
operation.
Make sure that foreign objects do not enter the
ejection area while the machine is in operation.
The machine and stacking table are not
installed on level place.
Install them at a level place.
The paper discharge parts of the
machine are exposed to direct light.
Shade light with curtains or the like, or move the
machine to a darker place so that the ejection area
will not be exposed to direct light.
The DOUBLE FEED
lamp lights even after
only one sheet of paper
has been fed.
Paper of different qualities are loaded
onto same feed table.
Make sure that sheets of the same quality are
loaded onto a paper feed table.
Differently printed paper is loaded
onto same feed table.
Make sure that sheets printed in the same way are
loaded onto a feed table.
Paper not conforming with
specifications is in use.
Use paper conforming with specifications.
Lamps for stations
repeatedly lights up and
go out while moving up
and down.
Troubles in the table lifting motor or
other electrical parts
Contact your dealer or authorized service
representative.
The Counter display
shows "LOCK" and the
machine stops operation
(“CRISSCROSS” is
switched to ON, and the
stacking table will not
move horizontally)
The stacking table is not set properly
Check if the discharged sheet table is properly set.
Do not move stacking
table.
It is set to straight stacking
Set to Crisscross stacking
Summary of Contents for FC 10 PLUS
