13
Remarks
a)
Make sure the stacking table and aligning wire are
properly attached to the machine; wrong attachment
may cause the machine to rock or paper to jam when
ejected.
b)
Take care so that fingers or hands are not caught in
collator operating parts.
Caution!
Make sure that the paper feed table, the auxiliary table and the stacking table are properly set.
They may cause an injury if they come off. Also, take care not to cause the machine to fall when
attaching or removing the stacking table and auxiliary table.
3.1.5
Switch Single/Option
When using an optional Staple punch, switch Single/Option.
Remarks
Note that an error will occur if the Paper
Ejection sheet switching plate is switched
to “
Option
” mode with no optional
Staple
punch connected.
Switch the Paper Ejection sheet switching
plate.
In Single mode:
The sheet collator is used
alone.
In Option mode:
The sheet collator is used
with an optional Staple
punch.
Paper Ejection sheet
switching plate
Paper Ejection Sheet
Switching plate
Summary of Contents for FC 10 PLUS
