60
(2)
List of system parameter
Item
Function
Initial
value
Key
Input
range
Contents
P
Double feed
Threshold level
Numeric
key
0
㹼
255
Not used
If the setting is changed, the double
feed detection function will not
properly operate.
A
Double feed detection
ON/OFF
1,2,3key
0 or 1
Refer section 11.2
L
Waiting time after paper
is fed
*1
Numeric
key
0
㹼
65.5
Setting of waiting time until next
paper feed when post-processing
equipment is connected.
n
Waiting time for
response of paper
ejection
*1
Numeric
key
0
㹼
65.5
Setting of waiting time for response
of paper ejection confirmation
signal at collator side when
post-processing equipment is
connected.
b
Waiting time after
swing stacking (high
speed)
Numeric
key
0
㹼
999
x10ms
Note that ejected sheets will not be
properly aligned if the setting is
excessively high.
If ejected sheets are not properly
aligned, collate them at “low speed.”
c
Clutch ON time for
stacker
Numeric
key
0
㹼
999
Not used
The amount of feed decreases when the
setting is decreases, or increases when
the setting is increased.
Note that paper feed will slip when the
setting is decreased, or the clutch will
malfunction when the setting is
increased.
d
Clutch ON Interval
for stacker
Numeric
key
0
㹼
999
Setting the amount of offset of each
station.
Sheets in the lower station will move
forward when the setting is decreased,
or will be fed in retard when the setting
is increased.
Note that the station will malfunction
when the setting is zero.
E
Waiting time after
swing stacking (Low
speed)
Numeric
key
0
㹼
999
x10ms
F
Not used
Numeric
key
0
㹼
999
Not used
G
Clutch ON Interval
for option in used *1
Numeric
key
0
㹼
999
Setting the amount of offset of each
station
Sheets in the lower station will move
forward when the setting is decreased,
or will be fed in retard when the setting
is increased.
Summary of Contents for FC 10 PLUS
