68
13.11 Station lamp lights red.
Check exterior
conditions
Slip of paper, etc. is caught in the paper feed
photo.
Remove the paper.
Ў
Photo-sensor is stained with paper dust.
Clean the paper feed photo.
Ў
Remove the cover on
the operator side
Do not emit paper feed sensor.
Check the paper feed sensor harness.
Check the paper feed photo harness.
The sensor is out of order.
Ў
Voltage between pins 2 and 3 of 5P connector
on the side plate is 0.9V or more.
Check the paper feed sensor harness.
Check the paper feed photo harness.
The sensor is out of order.
Ў
MAIN PCB or paper feed photo harness is
defective.
13.12 Door lamp remains lit.
Check exterior
conditions
Back door is open.
Close the back door.
Ў
Remove the face
cover on the operator
side.
When door switch connector is removed,
voltage between terminals on the operation
circuit board is DC4V or less.
Check the motor harness.
Ў
There is no continuity between COM and NO
of the door switch.
The door switch is out of order.
Summary of Contents for FC 10 PLUS
