3
Safety Precautions
*The repair of a product that is damaged or malfunctions because of failure to follow the instructions
in this manual may not be free of charge, even during the warranty period.
Notes on Installation
Notes on Power Supply
Notes on Use
Warning
Do not install the product at a place where there is alcohol, thinner or other
volatile substances, or an open flame.
Doing so may cause fire or electric shock.
Caution
Do not install or store the product at an unstable place or at a place prone to
vibrations from other machinery.
Doing so may cause the product to drop or fall over, resulting in injury.
When lifting or transporting the product, use both hands to hold the product
from the rear.
Lifting the product from front or side may result in poor weight balance, causing you to
fall or become injured.
Warning
Connect the power cord to a grounded outlet.
Failure to do so may result in the malfunction of the protection circuit and cause an
electric shock.
Do not connect or disconnect the power plug with wet hands.
Doing so may cause electric shock.
Do not use any voltage other than specified by the machinery.
Doing so may cause an electric shock or fire.
Do not use a damaged power cord.
Do not process the power cord.
Do not put anything heavy on the power cord.
Keep the AC inlet at least 8 cm from the wall.
Failure to follow these instructions could cause an electric shock or fire.
Warning
Do not use the product when it is acting abnormally, such as emitting smoke,
foul odors, or noises.
Doing so may cause an electric shock or fire. Power it off immediately and disconnect
the power plug from the outlet.
Do not disassemble or modify this product unless otherwise specified to do so
in this manual.
Doing so may cause an electric shock or fire.
Do not use the product when there is foreign matter, water, or another form of
liquid inside.
Doing so may cause an electric shock or fire.
Caution
Do not mount anything on the product or place anything heavy on it.
Doing so may cause the product to fall or break, resulting in injury.
If the product is not to be used for a long time, be sure to disconnect the power
cord from the outlet for safety purposes.
Do not use needles other than those that are recommended.
Doing so may cause some staples to become stuck.
Do not load a number of sheets that exceeds the specified limit.
Do not use any thick, broken, or old paper.
Do not feed any paper from a high position.
Do not push paper forcefully.
Doing so may hamper proper bookbinding.
