16 of 68
2.5.
OPERATOR POSITIONS/
LAYOUT/ OPERATION
AND MAINTENANCE AREA
Tier 1 OPERATOR POSITION
IMPORTANT!
To define the maintenance area
you need to consider about 1.5 m
on all sides of the machine (fig
2.3 on next page).
!
CAUTION
Only one operator is required to
operate the machine.
Tasks and positions are detailed
in
PAR.
(§)
2.5
of
this
publication.
Failure to follow the indications
above represents a possible
MISUSE
and
relieves
the
manufacturer from any liability
arising
from
incorrect
use/misuse.
The machine must be operated by one
single operator. The latter operates the
machine during the normal work cycle.
While using the machine the operator is in a
sitting position. He/she moves the machine
controls consisting of two steering levers
positioned on the left and right side of the
operator and the accelerator lever. All
controls are operated from a sitting position.
The machine can be started with the operator
seated only (a safety micro switch enables
starting only if the operator is seated). The
adjustments pertaining to processing (blade
tilting adjustment) are performed with the
operator in the working position.
The operator position (figure below) is also
an inspection location from where it is
possible to supervise the proper conduct of
the work cycle.
The 1 tier operator is responsible for carrying
out cleaning after use.
2
Tier
OPERATOR
(RESELLER-
SPECIALIZED DEALER)
The reseller (expert maintenance technician)
performs maintenance and repair tasks
designed by the manufacturer (compare
chapter 6 of this publication).
He/she always operates with the machine
stopped and power disconnected unless
expressly provided otherwise.
2.6.
GENERAL DESCRIPTION
The double trowel machine "
MK8-75
” is
designed and manufactured to perform
finishing (troweling) of concrete and
asphalt floors of sheds, car parks, cycle
paths, parking areas, sidewalks, etc
The power supply is provided by an
internal combustion engine running on
unleaded petrol.
The following table lists the functional
groups of the machine.
FUNCTIONAL GROUPS
MK8-75 TROWELING MACHINE
1
RIGHT ROTOR
2
LEFT ROTOR
3
BLADE TILT ADJUSTMENT LEVER
ON THE RIGHT
4
BLADE TILT ADJUSTMENT LEVER
ON THE LEFT
5
THROTTLE
6
RIGHT-SIDE CONTROL BAR
7
LEFT-SIDE CONTROL BAR
8
FUEL TANK
9
SEAT
10
ENGINE
11
WATER TANK
12
FEATHER EDGE DISCS
13
SAFETY DEVICES (SEE RELEVANT
PARAGRAPH)
Summary of Contents for MK8-75
