30 of 68
Machine installation and operations related
to it must only be carried out
by qualified
personnel of the user.
●
Always use protective shoes;
●
Never place hands or other body
parts under components which are raised or
could be pulled on by gravity.
●
Do not wear rings, watches, bracelets,
or clothes that are too large and dangling
during the assembly and/or maintenance
operations;
●
Do not perform actions outside their
field of knowledge and responsibility.
THE SYSTEM IN QUESTION CANNOT
OPERATE
IN
AN
EXPLOSIVE
ATMOSPHERE.
4.1
INSTALLATION
The
trowel
is
delivered
appropriately
arranged in its packaging, with steering
levers folded as shown in figure 3.1.
After unloading the machine from the means
of transport using a forklift and following the
completion of the unloading and unpacking
procedures:
●
Place the machine on the floor:
remember to remove the feather edge discs
for lifting at more than 1 m of height and put
them back before placing the machine on the
ground.
●
Insert the seat disassembled before
packing along the mounting rails on the
support plate (fig. 4.1) and fasten it with 4
bolts (fig. 4.1, a and b). Tighten the nuts
securely with the appropriate tool.
●
Mount the steering levers following
this procedure:
●
Insert the central tie-rod joint into its
housing (1), the side tie-rod joint (2) of the
side lever, screw and tighten the nuts
securely by means of the key 22.
●
●
Replace the lock of the tie-rods (fig.
4.3).
●
Connecting
the
battery
cable
:
remove the cover and fasten the relevant
cable to the negative terminal of the battery
(fig. 4.4) by tightening the clip with the
appropriate tool (13 key).
!
CAUTION
The environmental and
operating
conditions
must not hinder access
to the controls of the MACHINE.
The
machine’s
place
of
installation MUST be equipped
with good lighting and must be
free of shadows and glare that
may annoy the operator. The
minimum brightness level of the
work area and the area for
performing
maintenance
activities is 300 lux.
For this purpose, the machine is
equipped with two
lateral
12
Volt
lamps.
Figure 4.1
b
a
Figure 4.3
Figure 4.2
1
2
Figure 4.4
Summary of Contents for MK8-75
