33
Connection
b) Connecting the Outputs
MAIN OUT MASTER (19)
Connect the MASTER output to a free cinch input of your amplifier (e.g. AUX).
MAIN OUT BOOTH (20)
You can connect an additional amplifier to this output to be used in an adjoining room or to provide the signal for
monitor loudspeakers.
MAIN OUT TAPE (21)
If you wish to record the output signal from the mixing desk with a recording device, connect the recording input of
the device to the TAPE sockets (21) on the mixing desk.
PHONE connection (18)
Connect headphones with a 6.3 mm TRS plug to this output.
The headphone minimum impedance must be 32 Ohm.
c) Record Player Earth Connection
If your record player has its own earth line (usually a thin, black cable with clamp-type socket), connect it to earthing
screws GND (22). This helps prevent humming distortion.
d) Connecting the Power Supply
The mains socket to which the mixer is connected must be easily accessible so that the device
can be quickly separated from the mains voltage in case of an error.
Be careful when handling the mains cables and mains connection. Mains voltage can lead to
a fatal electric shock.
Make sure that no cables lie around openly. Install cables professionally to prevent accidents.
Make sure that all electrical connections and connection cables between the different devices
and any extension cables comply with the regulations and the operating instructions.
• Connect the mains connector to the mains connection (25) of the device.
• Put the plug of the power line into a earthed wall socket.
Summary of Contents for DJM-300
