E-1608 Quick Start
3
2.
If you cannot establish a connection, make sure the device is using
the default configuration by following the
Restoring factory default
network settings
procedure below.
Once a connection and communication is established, you can change
the configuration for other network scenarios. InstaCal is required to
install and configure the E-1608 on Windows platforms.
Restoring factory default network settings
To reset the network configuration settings to the factory default values,
complete the following steps:
1.
Remove power from the device.
2.
Press and hold the
Factory reset
button while re-applying power.
Hold the button for at least four seconds until the
Power
and
Activity
LEDs blink to indicate that the factory settings have been restored.
3.
Refer to Figure 1 for the location of the
Factory reset
button and
Power
and
Activity
LEDs.
4.
Release the button so the device continues startup with the default
settings. If the button is released before the two LEDs blink, the
settings are not affected and the device starts up normally.
If InstaCal is open when default settings are restored, click the
Refresh
Boards
button on the InstaCal toolbar to reflect the changes
1 Factory reset button
2 Power LED (top) and Activity LED (bottom)
3 Link/activity LED (left) and speed LED (right)
4 External power connector
Figure 1. E-1608 LEDs, buttons, and connectors
Distributed by MicroDAQ.com, Ltd. www.MicroDAQ.com (603) 746-5524
