REVERSING ROTATION OF ROTOR
SI Models
Fully extend the armhead and lower flail to the ground to minimise oil loss.
Release the hoses from the flail motor rigid pipes or the rotor control valve and interchange.
Do not
interchange the flail supply and return hoses at any other point as the hose routing
and cross overs in the installation are necessary to allow the hoses to flex correctly during
arm movements.
To ascertain the direction of cut without running the machine the following applies:
Connection
MP
- Lower motor rigid pipe}
upward cutting
Connection
MR
- Upper motor right pipe}
Connection
MP
- Upper motor rigid pipe}
downward cutting
Connection
MR
- Lower motor rigid pipe}
TI Models
Select rotor
‘OFF’
Wait until rotor has
stopped
turning
completely.
Rotate the lever on the side of Controls
through 180° to allow opposite rotation
to be selected
.
GRASS CUTTING
Flails must always cut upwards when the machine is being used for Grass Cutting
31
Summary of Contents for PA 48
