56
Manual Controls Operation
(refer to control illustration above)
Starting the engine;
Set E-Stop button in the de-activated position.
Press rocker button at point ‘1’ to switch ignition ON.
Press button ‘2’ to start engine, release button as soon as engine starts.
Stopping the engine;
Press button at point ‘3’ to switch ignition OFF and stop the engine.
Driving & manoeuvring the machine;
Forward travel is by simultaneous operation of buttons at points ‘A’ & ‘B’.
Right turn is by operation of button ‘A’ only.
Left turn is by operation of button ‘B’ only.
Reverse travel is by simultaneous operation of buttons ‘C’ & ‘D’.
Counter-rotation to the right is by simultaneous operation of buttons ‘A’ & ‘D’.
Counter-rotation to the left is by simultaneous operation of buttons ‘B’ & ‘C’.
Raising the tool is by operation of button ‘E’.
Lowering the tool is by operation of button ‘F’.
Charging Station for Remote Control Battery
The machine’s remote control unit is supplied with a spare battery for use as a reserve.
A charging station for control unit batteries is ‘built-in’ to the receiver unit located in the
front compartment of the machine.
For uninterrupted operation, the reserve battery can be stored in the charging station; this
will ensure it remains fully charged and ready for use.
Location of
Remote Battery Charging Station
The charging station only provides power to the battery whilst the engine is running; It will
automatically cut out when the battery reaches its fully charged state.
