121
Operation
5
Implement hitch dimensions.
a - Horizontal distance between lower link pins of the
three-point hitch and the implement’s centre of
gravity.
As small as possible (the greater is the weight of the
implement, the smaller it is).
b- Retraction of the third point: 0 to 80 mm (0 to 3.1 in.)
c- Height of top link hitch ball: 500-600 mm (19.7 to 23.6
in.)
d- Length of bar: 825+1.5 mm (32.5 in.)
NOTE:
The plough shown in the figure is purely indi-
cative since the dimensions are valid for any type of
implement.
Three point linkage
The three point linkage is used to connect the tractor to
implements controlled by the hydraulic lift.
The three-point linkage is suitable for connection to
implements of 2nd class as shown by the diagram and
data given in the figure.
WARNING: Always take great care when
using or adjusting the three point linkage.
Hitching the implement
To allow the lift to operate in the correct way, you must
carefully check the dimensions of the implements to be
coupled to the tractor.
These couplings must be the same standard size as the
three point linkage of the tractor to prevent the whole
assembly from being subjected to irregular stress du-
ring work, caused by dimensional incompatibility. See
dimensions given in the figure.
Weight of the implement
To prevent the regular operation of the lifting system
from being impaired, the weight of the implements
must be less than the maximum load the lift can raise.
This value (given in the specifications) is only indicative,
since the distance at which the center of gravity of the
implement is set in relation to the three point linkage
can also exercise a notable influence.
If an implement, even when lighter than the indicated
weight, is set at an excessive distance from the tractor,
it will bear down on the three point linkage with a much
greater weight than the weight of the implement itself.
Three point linkage components
The articulated device with three point suspension
mainly consists of the following components:
1 - Adjustable top link with length adjuster sleeve
2 - Adjustable rh lift rod.
3 - Rh rod adjustable fork
4 - Lateral stabilizers (2 pcs).
5 - Lower links.
6 - Hitch couplings.
7 - Lh rod adjustable fork.
8 - Lh lift rod.
Mechanically adjusted three point linkage (Class 2).
Summary of Contents for X60 Series
