158
Tyres, Wheels, Ballasting
Adjusting wheel track
4WD axle - Adjusting wheel track
The front track on 4WD tractors can be adjusted by chan-
ging the position of the hubs and central wheel discs as
shown in the table below.
Make sure that the wheel nuts are correctly tightened to
the prescribed torque wrench setting:
Disk to hub: 270 Nm
Rim to disk: 210 Nm
IMPORTANT: After removing and fitting the wheels back
again, it is important to check the torques of all bolts by
means of a torque wrench at the following intervals:
- First check after 10 work hours.
- Second check after 50 work hours.
- Third check and further checks every 500 work hours.
WARNING: When you lift up the tractor to
adjust the wheel tracks, follow the directions
for lifting in the Safety Notes section.
WARNING: Maximum attention must be used
when dismounting the front wheels: because
of their weight, a suitable hoist must be used
to remove and handle the wheels.
Summary of Contents for X60 Series
