216
Maintenance
2000 HOUR MAIN SERVICE
CAUTION: If you need to open the bonnet, follow the procedure indicated under “How to open the bonnet”.
WARNING: Always use specific personal safety devices for each operation.
WARNING: Maintenance operations must be carried out with the engine off. Check that the gear and the par-
king brake are both engaged and that the ignition key has been removed.
WARNING: Beware of burns caused by hot tractor and engine parts.
[4.1.n]
Engine coolant change
OPERATION 1
Remove the radiator cap slowly (2).
WARNING: Hot coolant can spray out if the
coolant recovery reservoir cap or radiator
cap is removed while system is still hot. DO
NOT REMOVE THE RADIATOR CAP. To remove
the coolant recovery reservoir cap or ra-
diator cap, let system cool, turn cap to first
notch, then wait until all pressure is released.
Scalding can result from fast removal of
radiator cap.
OPERATION 2
Put a suitable container under the engine block drain plug
(1) and remove plug.
OPERATION 3
Put a hose on the radiator drain valve (2) and open the
valve (if equipped). Drain coolant into a suitable container.
Otherwise, remove the bottom tube from the radiator and
connect a hose to drain the coolant into a suitable vessel.
IMPORTANT: Dispose of drained coolant responsibly. DO
NOT pour on the ground or into a drain. Be responsible
for the environment.
OPERATION 4
Close the radiator drain valve (2) (or fit the removed tube
back on again) and install the drain plug (1) when the
system is empty.
OPERATION 5
Use a good quality radiator cleaner and fill the system.
Follow the instructions given with the radiator cleaner to
clean the system.
OPERATION 6
Remove the engine block drain plug and open the ra-
diator drain valve (or remove the tube from the bottom).
Flush the system with clean water to remove the radiator
cleaner solution.
IMPORTANT: Allow cleaning solution to drain into suitable
vessels. Dispose of the cleaning solution responsibly. DO
NOT pour on the ground or into a drain. Be responsible
for the environment.
OPERATION 7
Inspect the hoses and fittings for damage and leaks.
OPERATION 8
Install the engine block drain plug, close radiator drain
valve (or fit the removed tube back on again) and remove
the drain hose.
OPERATION 9
Fill the radiator and coolant recovery reservoir using the
following procedure.
- Fit back the plugs 3 and 5.
- Start the engine and run at low idle for approximately
10 minutes.
- Stop the engine and check the coolant level.
Top up, if required, to the MAX mark on the reservoir (4).
Summary of Contents for X60 Series
