AutoDRIVE Keypad Replacement
IMPORTANT NOTICE - READ CAREFULLY
800.292.2737 | sales@aymcdonald.com | aymcdonald.com
Page 2 / 2-22
3210-689
Remove the four (4) CAT5 cables
that connect the control board to the
inverter board.
Remove the four (4) screws that attach
the control board to the inverter board.
Turn the control board over and remove
the four (4) screws that attach the
keypad panel to the control board.
Pull up on the plastic connector for the keypad ribbon cable and disconnect the ribbon cable that runs from the
keypad panel to the control board.
Step 2
Step 3
Step 4
Step 5
