MCDonald SD1-2HP2PS Replacement Download

Page: 4 / 4

AutoDRIVE Keypad Replacement

IMPORTANT NOTICE - READ CAREFULLY

800.292.2737 | sales@aymcdonald.com | aymcdonald.com

Page 4 / 2-22

3210-689

Install the four (4) screws that attach the
control board to the keypad panel.

Reinstall the front cover, reinstall
the three (3) screws, tighten the
front cover, and reconnect power to
the unit.

Install the four (4) screws holding the
control board to the inverter board.

Re-connect the four (4) CAT5 cables that
connect the control board to the inverter board.
In order/do not cross.

Step 9

Step 12

Step 10

Step 11

4800 Chavenelle Road | Dubuque, IA 52002

1-800-AY-CARES | aymcdonald.com | aymcdonaldu.com

WITHOUT

YOU

THERE IS NO

(292-2737)

Summary of Contents for SD1-2HP2PS

Page 1: ...quate time to discharge before servicing Reference the sticker on the side of the drive for specifics on capacitor discharge time This instruction applies to the following AutoDRIVE model numbers Kit...

Page 2: ...board to the inverter board Remove the four 4 screws that attach the control board to the inverter board Turn the control board over and remove the four 4 screws that attach the keypad panel to the co...

Page 3: ...old keypad Peel the clear plastic adhesive scratch protector off the back of the keypad and then peel back the adhesive backing from the new keypad feed the ribbon cable through the hole in the keypad...

Page 4: ...all the three 3 screws tighten the front cover and reconnect power to the unit Install the four 4 screws holding the control board to the inverter board Re connect the four 4 CAT5 cables that connect...