McDonald's 9210859, Manual

HEBT-3V BUN TOASTER

6

P/N 1011377 Rev. G   07/17 

McDonald’s

Operating Instructions

The HEBT-3V toasts Crowns, Heels, Clubs, and other 

products. Follow these steps to start the HEBT-3V:

  1.  Turn on the toaster and wait for warm-up to com-

plete.

  2.  Set the Compression Knob to 4 (recommended). 

If further adjustments are required see page 8 

under Adjusting Toast Quality. Refer to the figure 

on page 7.

  3.  When the unit reaches operating temperature, the 

control panel displays “Ready”. 

   4.  Insert product into the designated area of the Bun 

Feeder Assembly with the cut side of the bun fac-

ing towards the front. Toasted product drops into 

the Bun Buffer.

OPERATION

Figure 2. HEBT-3V Control Panel and Display

User Mode

User Mode allows an operator to view the toaster set-

tings but does not permit any adjustments.

  1.  Press and hold the 

PROGRAM

 button for 5 sec-

onds. After 5 seconds, the display will show the 

actual temperature of Platen A (front).

  2.  Press the 

LIGHTER

 button to toggle between 

the setpoint and actual temperature of Platen A 

(front).

  3.  Press the 

PROGRAM

 button to proceed to the 

Front Platen Heater menu. The display shows the 

actual temperature of Platen B (rear).

  4.  Press the 

LIGHTER

 button to toggle between the 

setpoint and actual temperature of Platen B (rear).

  5.  Press the 

PROGRAM

 button to proceed to the 

Motor Menu. The display shows the actual speed 

of the motor.

  6.  Press the 

LIGHTER

 button to toggle between the 

setpoint and actual speed of the Motor.

NOTE:  The unit will exit User Mode after 5 seconds 

of keypad inactivity.

Manager Mode

Manager Mode allows an operator to view and adjust 

the following settings:

•  Platen A Temperature

•  Platen B Temperature

•  Motor Speed

•  Temperature Units (Celsius or Fahrenheit)

•  Current Selection: 208 or 240 volts

Manager Mode also allows an operator to view (but 

not adjust) the Ambient Temperature of the Control 

Compartment as well as the number of days of opera-

tion.

  1.  Turn the unit off.
  2.  Turn the power on while holding the 

PROGRAM

button. Hold the button for 5 seconds until the dis-

play shows “EnA.” Release the button.

  3.  To adjust the Platen A (front) Setpoint 

Temperature, press the 

LIGHTER

 or 

DARKER

buttons to reach the desired temperature.

NOTE:  The recommended temperature setting for 

Platen A (front) is 271° C (520° F).