Fusion Equipment Safety
Fusion Procedures
Obtain a copy of the pipe manufacturer's procedures or
appropriate joining standard for the pipe being fused. Follow the
procedure carefully, and adhere to all specified parameters.
NOTICE:
Failure to follow pipe manufacturer's procedure
could result in a bad joint. Always follow pipe
manufacturer's procedures.
TX04469-10-24-12
WR000
79-1-
24
-9
6
1 - 5
Facer Blades Are Sharp
Facer blades are sharp and can cut. Never attempt
to remove shavings while the facer is running, or is
in the facing position between the jaws. Use care
when operating the facer, and when handling the
unit.
NOTICE:
Disconnect power from the facer, and remove the facer
blades before attempting any maintenance or adjustment.
NOTICE:
Never extend the blade beyond the inner or outer
circumference of the facer.
TX02378-1-24-05
WR000
73
-4
-6
-9
3
Heater is Hot
The heater is hot and will burn clothing and skin.
Keep the heater in its insulated heater stand or
blanket when not in use, and use care when
heating the pipe.
NOTICE
: Use only a clean non-synthetic cloth to clean the heater
plates.
TX00104-01-03-14
WR000
30
-2
-10
-9
3
Personal Lifting Safety
The machine components are heavy. Using one
person to lift the facer or carriage may result in
an injury. Use a lifting strap and an overhead
lifting device to lift facer or carriage. For manual
lifting, two people are required to lift the facer or
carriage.
TX05159-09-22-16
H
ea
vyL
ifting5-
25-10
Summary of Contents for DynaMc 250HP
Page 44: ......
