Overview
2 - 4
Facer
Electric motors are not explosion proof. Operation of
these components in a hazardous environment without
necessary safety precautions will result in serious injury
and death.
Ensure facer power switch is in the off position.
Connect facer to proper power source.
Don't turn on facer until ready to face.
Remove brushes on the Milwaukee facer motor:
The armature brushes must be removed from the electric motor when
manually operating in a hazardous condition. Unscrew the brushes from
both sides of the motor. (Both brushes must be removed). A 1-1/8" hex
shaft allows for manual operation in hazardous conditions.
Remove brushes on the Eibenstock facer motor:
The armature brushes must be removed from the electric motor
when manually operating in a hazardous condition.
Remove the rear cover of the motor.
Slide the spring clip away from the brush and pull the brush out
(A).
Loosen the brush ground wire (B) and pull the wire loose.
Repeat these steps on the wire on the opposite side.
Store the brushes in a safe location until needed.
A 1-1/8" hex shaft allows for manual operation in hazardous
conditions.
TX04004-04-07-14
PH
0412
5-
4-12
-10
¡PELIGRO!
PH018
47
-7
-2
5-00
PH
0412
9-
4-12
-10
PH
0413
0-
4-12
-10
PH
0413
0-
4-12
-10
B
A
Summary of Contents for DynaMc 250HP
Page 44: ......
