Check Hydraulic Fluid Level
Check fluid level by removing the plug on the top of the hydraulic
pump's reservoir. The reservoir should be approximately half full of
fluid. Do not overfill.
Refer to the "Hydraulic Fluids" section of this manual for hydraulic
fluid recommendations.
TX02954-08-08-14
Read Before Operating
Before operating this machine, please read this manual
thoroughly, and keep a copy with the machine for future
reference.
The fusion procedures in this manual are for use with
polyethylene pipe. If fusing other thermoplastic pipe materials,
refer to the pipe manufacturer's suggested procedures or
appropriate joining standard.
TX02953-4-15-09
Butt Fusion Procedure
ST
OP
-12
-2
2-
92
3 - 1
Prepare Heater
Heater is not explosion proof. Operation of heater
in an explosive atmosphere without necessary safety
precautions will result in serious injury or death.
If operating in an explosive atmosphere, heater should be brought
up to temperature in a safe environment, then unplugged before
entering the explosive atmosphere for fusion.
Install butt fusion heater plates.
NOTICE:
The heater should never be used without butt fusion heater
plates installed. Refer to the "Maintenance" section of this manual
for installation procedure.
Place heater in insulated heater stand.
Plug heater into a proper power source.
Allow heater to warm-up to operating temperature.
Refer to the "Maintenance" section of this manual for instructions on
how to adjust heater temperature.
TX02310-03-24-14
PH
02
31
2-
4-
24
-02
¡PELIGRO!
PH00
42
0-11-1-9
4
PH
03
861-
4-15-0
9
Summary of Contents for DynaMc 250HP
Page 44: ......
