Heater
Heater is not explosion proof. Operation of heater in an
explosive atmosphere will result in serious injury or death.
The heater has a green indicator light which will flash on and off. This
indicates that the controller is operating normally. If the green indicator is
not flashing then the controller may not be operating properly. If this occurs,
disconnect power and have the heater repaired by a McElroy Authorized
Service Center.
The heater temperature is controlled by a microprocessor. It has a red indicator
light on the bottom of the temperature scale. When the heater is plugged in
and preheating the light glows steadily until the set temperature is reached. The
light then goes off and on slowly as the heater maintains temperature.
The heater body is not coated. Coated socket fusion heater adapters are
available for all socket fusion applications.
NOTICE:
The heater should never be used without socket fusion heater
adapters installed.
To prevent a build-up of plastic pipe residue from accumulating on the heater
adapters (loss of surface temperature and pipe sticking may result), the heater
adapters should be cleaned with a clean dry lint free non-synthetic cloth before
every fusion joint.
The heater pivots in and out of the fusion area. The heater can be rotated to
change the position of the heater adapters from one side to the other to allow
fusion on both ends of the machine.
To rotate the heater, pull the handle of the heater with the round ball toward
the heater and rotate the heater.
TX04851-12-14-15
CD0
14
11-1
1-30-1
5
CD0
14
11-1
1-30-1
5
Overview
2 - 3
¡PELIGRO!
CD0
1440-1
1-2
3-1
5
CD0
14
15-1
1-2
3-1
5
CD0
145
2-1
2-0
1-1
5
Fitting Heater Adapter
Pipe Heater Adapter
Summary of Contents for SmartFab 125
Page 1: ...Manual 460801 Revision Rev C 06 19 Operator s Manual Original Language English SmartFab 125...
Page 30: ......
Page 32: ......
