Set Up Calibration (continued)
Select a fitting, the appropriate inserts and heater adapters to
match.
Install the heater adapters on the heater. The pipe heater adapter is
installed on the side of the heater with the long heater stops.
Install the inserts with the stops on the inner jaw frame.
Install pipe and fitting into the machine. The fitting will be inserted
against the inserts with the stops on them.
Slowly advance the movable jaws until the fitting is close to the
heater adapter.
Using a 7/16" wrench, loosen the locking nut on the back of the
heater swivel assembly.
Adjust the center height of the heater to match the fitting to the
vertical alignment of the heater adapter.
Tighten the locking nut.
TX04857-03-14-16
CD0
1430-1
1-2
0-1
5
CD0
143
1-1
1-2
0-1
5
CD0
143
2-1
1-2
0-1
5
3 - 5
Set Up
Fitting Heater Adapter
Pipe Heater Adapter
Summary of Contents for SmartFab 125
Page 1: ...Manual 460801 Revision Rev C 06 19 Operator s Manual Original Language English SmartFab 125...
Page 30: ......
Page 32: ......
