14
In Case of Emergency
Overheating
If the temperature gauge indicates overheating, if you experience power loss or if you hear a loud
knocking or pinging noise, the engine is probably too hot.
In case this happens, drive to any area where it is safe to stop and set the transaxle in neutral position,
and then follow these steps:
1.
Check whether steam is escaping from the engine compartment
2.
If steam is coming from the engine compartment, don’t go near the front of the
tractor
3.
Stop the engine and let it cool
Emergency Starting
Jump-starting is dangerous if done incorrectly. It is recommended to follow the following procedure
carefully:
1.
Make sure the booster battery is 12 volts and that its negative terminal is grounded
2.
If the booster battery is in another vehicle, don’t allow the vehicles to touch. Turn
off the engine of the vehicle with the booster battery and all unnecessary electrical
loads in both vehicles
3.
Connect the jumper cables in the exact sequence as listed below:
4.
Connect one end of one cable to the positive terminal (red) on the discharged
battery
5.
Attach the other end of this cable to the positive terminal (red) on the booster
battery
6.
Connect one end of the other cable to the negative terminal (black) of the booster
battery
7.
Connect the other end to the negative terminal (black) of the discharged battery
8.
Start the engine of the booster vehicle and run it a few minutes. Then start the
engine of the other vehicle
9.
When finished, carefully disconnect the cables in the reverse order described in
step 3
Note
It is not possible to push start the MR18.
Summary of Contents for utrac MR18
Page 1: ...Scale Tractor Team trac MR18 Owner s Manual...
Page 29: ...29 Wiring Diagrams...
Page 30: ...30...
