Page 17
For technical questions, please call 1-888-866-5797.
Item 64857
Sa
F
ety
Opera
ti
O
n
Maintenance
in
S
talla
ti
O
n
problem
possible causes
likely Solutions
Excessive noise
1� Loose fittings�
2� Crankcase overfilled with oil or
oil is incorrect thickness or type�
3� Crankcase oil level too low�
4� Unit not on level surface�
1� Reduce air pressure, then check all
fittings with a soap solution for air
leaks and tighten as needed� Do not overtighten�
2� Drain oil and refill to proper level with recommended oil�
3� Add oil to proper level, check for leaks�
4� Reposition unit on a level surface�
Moisture in
discharge air
Too much moisture in air�
Install inline air filter/dryer, and/or relocate
to less humid environment�
Safety Valve “pops”
Safety valve needs service�
Pull on test ring of safety valve� If it still pops, replace�
Air leaks from
pump or fittings
Loose fittings�
Reduce air pressure, then check all fittings with a soap solution
for air leaks and tighten as needed� Do not overtighten�
Air leaks from tank
Defective or rusted tank�
Have tank replaced by a qualified technician�
Drain moisture from tank daily to prevent future corrosion�
Oil in discharge
air or high oil
consumption
1� Crankcase oil too thin or
crankcase overfilled with oil�
2� Unit not on level surface�
3� Crankcase vent clogged�
1� Drain oil and refill to proper level with recommended oil�
2� Reposition unit on a level surface�
3� Clean Crankcase vent�
Follow all safety precautions whenever diagnosing or servicing the compressor.
Disconnect power supply before service.
pleaSe reaD tHe FOllOWinG careFUlly
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM
IN THIS MANUAL AS A REFERENCE TOOL ONLY� NEITHER THE MANUFACTURER OR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS
QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE
ANY PARTS OF THE PRODUCT� IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND
LICENSED TECHNICIANS, AND NOT BY THE BUYE R� THE BUYER ASSUMES ALL RISK AND LIABILITY
ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS
THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO�
record product’s Serial number Here:
note:
If product has no serial number, record month and year of purchase instead�
note:
Some parts are listed and shown for illustration purposes only,
and are not available individually as replacement parts�
