McHale
995 L+T
Square Bale Wrapper
16
4
Specific Safety Warnings
4.1 Electronic safety warnings
This machine is equipped with electronic parts and components which comply
to the EMC directive 2004/108/CE but still may be influenced by
electromagnetic transmissions of other apparatus, such as welding machines,
etc.
Check electric cables regularly for signs of breakage or wear. If in doubt
always replace (faulty safety circuits will cause risks).
Do not modify any safety circuits
4.2 Hydraulic safety warnings
The maximum pressure in the hydraulic system of this machine should not
exceed 210 bar.
Always ensure the system is not under pressure before working on the
machine. Oil under pressure can penetrate the skin and cause injury.
Hydraulically actuated devices, such as the table tip must be blocked
mechanically against movement, before working on the machine.
If any hoses are removed or replaced ensure they are marked and re-installed
to the correct position during re-assembly.
Check hoses regularly for signs of leakage or wear. Use a piece of card when
checking for leaks. Fine jets of hydraulic fluid can penetrate the skin. Never
use your fingers or face to check for leaks. If in doubt always replace.
The
recommended maximum working time of hoses should not exceed 5 years.
Only use exact specification
McHale
genuine replacement parts.
As the cut and hold is kept open by gas accumulator pressure, it will be
necessary to release this before removing the accumulator or working on the
hydraulic cylinder. Otherwise injury may occur. If in doube entrust the job to
your
McHale
dealer.
Do not work on hydraulic systems unless you are qualified to do so. This work
should only be carried out by qualified persons or your
McHale
dealer.
