McHale
995 L+T
Square Bale Wrapper
25
5.3 Attaching the wrapper (L Series)
1.
Attach the lower link bar to the tractor lower links. Secure with linch pins
provided (tractor only)
2.
Reverse the tractor up to the wrapper, lining up the lower links of the tractor
with the wrapper. Lift the hitch bar into the latch ensuring both sides have
latched in properly (tractor only)
3.
Attach the top link on the tractor to the top link holder on the wrapper (tractor
only)
4.
Plug the hydraulic feed hose into a suitable hydraulic spool valve. Ensure the
control valve is correctly configured for the type of hydraulic system on the
tractor. Refer to “Hydraulic spool valve setup” on page 24 for more details.
5.
Plug the hydraulic return hose into a connection that has a freeflow into the
back of the tractor/power pack. It is very important to ensure that it is in freeflow
to get the best results from the wrapper.
6.
Place the electronic box (995 LSR) or bale wrap computer (995 LS) in the
tractor cab and secure it to the glass in an appropriate place, using the suction
pad on the rear. The safety strap must be secured to protect the box from
accidental damage. If there is no cab on the tractor secure as appropriate,
bearing in mind the box is not waterproof. If using a power pack attach it in a
suitable position where it cannot be damaged.
7.
Screw the 37 pin socket on the electronic box and the 37 pin plug on the
machine together (995 LSR). Connect the control box to the trailer socket or
battery, using the power cable provided. There must be a good 12 V supply to
the control box.
8.
Connect the bale wrap computer (995 LS) to the trailer socket or
direct to the
battery, using the power cable. There must be a good 12 V supply to the bale
wrap computer.
9.
Check that all of the above functions operate correctly.
10.
The machine is now ready to work.
5.4 Attaching the wrapper (T Series)
1.
Reverse the tractor up to the wrapper, lining up the tractor hitch with the
wrapper hitch-eye. Fit the tow pin to the hitch ensuring it is secure, by inserting
a linch pin.
2.
Screw the jack up fully, off the ground.
3.
Plug the 7 pin lighting plug into the 7 pin socket on the tractor.
4.
Now follow the instructions from No. 4 in “Attaching the wrapper (T Series)”
(Section 5.3)
CAUTION: Control levers must be stored appropriately
For 995 L and 995 LS place the control levers in an appropriate place,
either on the machine or on the tractor. Cable controls may be placed
in the cab if desired. However manual spool valve controls must be kept
outside the tractor cab.
