McHale
995 L+T
Square Bale Wrapper
46
8.6.4 To Set Wraps
To change the desired/target number of film wraps:
1.
Press the Down Arrow (Button 4) twice, from the working screen, to display the
To Set Wraps Screen
2.
Press Enter (Button 3) to move to the Use To Set Screen
3.
Use the Up and Down Arrows (Buttons 1 & 4) to make changes to the first
flashing digit and when the desired figure is displayed, press Enter (Button 3).
The second digit is programmed in a similar manner. When the target number
of wraps is displayed, return to the working display by pressing ESC (Button 2)
or the Up Arrow (Button 1) twice.
8.6.5 Operator Setup
To enter the Operator Setup Menu:
1.
Press the Down Arrow (Button 4) three times from the working screen
2.
Press Enter (Button 3) to move to the Operator Setup options:
Slow Down Time
Wrapping Sequence/Program
Film Sensor
Display Contrast
Remote type
Continuous Cycle
Auto Load Set up
3.
Use the Up and Down Arrows (Buttons 1 & 4) to select an item, press Enter
(Button 3) to adjust the current selection/setting.
Slow Down Time
This setting determines when the table goes into slow down speed at the end of a
wrapping cycle. The adjustment range is from 1 to 4 sensor pulses. (There are 2 sensor
pulses per table revolution). To change the slow down time:
1.
Press the Down Arrow (Button 4) three times
2.
Press Enter (Button 3) once to move to the Select Slow Down Time Screen &
press Enter again to adjust the setting
3.
Use the Up and Down Arrows (Buttons 1 & 4) to change the value, press Enter
(Button 3) to save the new setting.
Wrapping Sequence/Program
CAUTION: Select the correct wrapping sequence before using the
machine
The “Expert Series” Electronic Control Box is designed to control a
number of different
McHale
wrapping machines, therefore, it is very
important that the correct wrapping sequence be selected to suit the
machine in use, before work begins.
