McHale
995 L+T
Square Bale Wrapper
50
Continuous Cycle
The Continuous Cycle, when enabled, allows the wrapping machine to complete the
wrapping cycle without waiting for the operator to press Table Tip (Button 7) to start the
tipping part of the cycle. Every time the Electronic Control Box is switched on, it asks
the operator to press Enter (Button 3) to confirm that the Continuous Cycle is required.
To turn the continuous cycle On/Off:
1.
Press the Down Arrow (Button 4) three times, to select the Operator Setup
Menu
2.
Press Enter (Button 3)
3.
Press the Down Arrow (Button 4) five times and press Enter
4.
Use the Up and Down Arrows (Buttons 1 & 4) to select On/Off
5.
Press Enter (Button 3) to save the new setting
Auto Load Setup
The Auto Load feature, when selected, enables automatic loading of the bale. The
loading arm normally sits at the preset float position. On approaching the bale, “Auto
Start” (Button 14) is pressed, the loading arm drops to the preset lower position and the
machine is moved forward to receive the bale. “Auto Start” is pressed again; the
loading arm lifts the bale onto the wrapping table, the arm lowers to the float position
and wrapping starts. Both the float position and the lower position may be adjusted. To
set the Lower/Float Position:
1.
Press the Down Arrow (Button 4) three times, to select the Operator Setup
Menu
2.
Press Enter (Button 3)
Figure 8.e - Radio Receiver
Figure 8.f - Radio Remote
CAUTION: Do not use the continuous cycle on hilly terrain
The continuous cycle should not be used in hilly terrain as the operator
needs better control of bale unloading i.e. the bale should be unloaded
on level ground.
Table forward
rotate
Starts Auto cycle/
Starts Auto tip
Table down
Close cut &
hold
Open cut &
hold
Table up
Emergency
Stop
Table
reverse
rotate
